Part No.

The laser head provides both laser source and detector. This connects via a cable to the data capture PC. The 5519A can be replaced with the 5519B laser head enabling higher measurement velocity (1.0 m/s).

PC Calibrator Board with Software and Encoder Input Cable.

10887B

The PC Calibrator Board is the interface between the Laser head and the PC. It is mounted either in data acquisition PC or in the USB Expansion Module (55292A) allowing connection to laptop computer, powerful windows software is also supplied.

PC Material Compensation / Wavelength Of Light  Board.

The PC Material Compensation / W O L Board is the interface between the air sensor and material sensors. These sensors monitor the air conditions and the material temperature at up to 3 positions to enable accurate corrections to be applied to the wavelength of light. These measurements compensate for environmental changes during measurements.

The Remote Control connects to the PC calibrator board to enable measurements to be taken remotely at the push of a button .

The Air Sensor monitors the temperature and air pressure of the surrounding environment allowing the appropriate wavelength of light corrections to be applied.

Material Temperature Sensor for measurement of material temperature allowing the appropriate thermal corrections to be applied, a magnet holds the sensor in contact with the material surface. Up to 2 additional sensors can be added with varying cable lengths to monitor material temperature across a structure..

Cable used to connect the laser to the PC calibrator board. Alternative lengths can be supplied 

Supports the laser head. The tripod can be adjusted vertically and horizontally as well as angularly in these planes to aid easy laser alignment

10786S

Durable ABS transit case to transport and protect laser head Cables and Optics. The optional 10787S case can be used for the transit of the tripod, material and air sensors and other accessories.

Linear / Angular

Combination Linear/Angular Kit

10787S

Durable and robust ABS transit case to transport and protect tripod, air and material sensors, fixturing etc. When used in conjunction with 10786S the whole laser system except the PC can be transported in just two cases, by land, sea, or air wit no additional packaging.

10744A

The Fixturing Kit contains extra posts plates etc. to enable more options for mounting laser optics. This kit can be used to build a rigid structure that helps to calibrate in the centre of the work zone to avoid abbe´ errors.

The USB Expansion Module accepts a 10887B calibration board a 10886A compensation board providing a USB interface to the Agilent / Hewlett Packard laser system.

5529U

The Upgrade Kit is used to upgrade the 5528A system, includes adapter cables, software and PC boards. Uses the Hewlett Packard 5518A laser head and any Agilent calibrator optics (5526A, 5528A and 5529A).

10767B

The lightweight reflector weighs 41 grams (1.4 oz.).It is specifically for applications that are weight sensitive, such as CMM calibration.

10757F

Addition material temperature sensors can be added (up to a maximum of 3). The use of 3 temperature sensors allows a more realistic measurement of the machine temperature to be taken as the sensors can be distributed over the machine structure.